Rivera Knucklehead Reverb KR 100 T Anleitung zur Fehlerbehebung PDF herunterladen (Seite 16)

Knucklehead Reverb 1.0 p 16

Sub Woofer Output Jack

This jack is primarily designed to drive a powered subwoofer. The signal produced at

this jack has all of the EQ from the preamp, but NO effects. Its level is controlled by the

SUB LEVEL control on the front panel. It is NOT low-pass filtered! It provides the Full-

Frequency signal to the subwoofer, the subwoofer must handle any low-pass filtering.

This is not a speaker output, so never connect it to a speaker jack and always use a

shielded cable when connecting it to an external power source.

Recording Output

The RECORDING OUTPUT is primarily designed to connect the amp to a Mixer or

Recorder. The Recording Out is equalized and calibrated internally, so every bit of tone

from your Preamp, and effects (if used) is sent from this jack. Although the recorder or

mixer doesn't receive the tone that comes from the speaker or the power amp section, it

does receive all of the signal from every other stage of the Preamp, and for live-

performance recording it does an excellent job of isolating your guitar sound. By

switching the Standby switch “Off”, you will be able to utilize the entire Preamp section,

including the Recording Output. This means of course that when the Standby if “Off”,

there will be no sound coming from the Speaker Outputs. This is perfect for silent

recording, or when multiple s are used and you only want one or two of them to power

speaker cabinets.

Warning: Do not connect the Recording Out to speakers or

headphones. For further information, refer to the hookup

diagrams for proper connection.

Driving Other Amplifiers

Although there is no specific SLAVE AMPLIFIER OUTPUT, There are several choices

available for driving another amplifier as a slave.

If you are not using an effect in the Effects Loop, you can use the EFFECTS SEND, it

provides a signal from the Preamp Post-EQ and Post-Reverb.

If you are not using a subwoofer, you can use SUB OUTPUT. It is the same as the

Effects Send, except it is controlled by a different knob.

If you want the second amp to have Effects, use the RECORDING OUT. It is Post-EQ,

Post-Effects and Post-Reverb. Its level is fixed.

Impedance Selector

Set the Impedance Selector to match the impedance load of your cabinets. Here's how:

4-ohm setting = One 4-ohm cabinet or two 8-ohm cabinets (one plugged into each

speaker output).

8-ohm setting = One 8-ohm cabinet or two 16-ohm cabinets (one plugged into each

speaker output).

16-ohm setting = One 16-ohm cabinet plugged into the Speaker 1 jack

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Keine Kommentare

Rivera Knucklehead Reverb KR 100 T Anleitung zur Fehlerbehebung Seite 16